automatic industrial sampling
PDP Pneumatic Line Sampler
The PDP pneumatic line samplers samples materials from light to heavy density powder, granules, flakes or other materials, in a pressurized conveying line or pressure vessel. This product must be installed perpendicular to the product line and for optimal performance should be 30 degrees down from horizontal. Additionally, the sampler should be located where the product has a non-turbulent flow pattern.
When activated a double-acting pneumatic cylinder forces the slotted sampling tube (probe) into the product line to collect a sample of the material. Next, the probe is withdrawn into the seal housing isolating the sample and sample tube cavity from the conveying line. The sample then falls down and out of the discharge tube to the desired sample collection point.
When activated a double-acting pneumatic cylinder forces the slotted sampling tube (probe) into the product line to collect a sample of the material. Next, the probe is withdrawn into the seal housing isolating the sample and sample tube cavity from the conveying line. The sample then falls down and out of the discharge tube to the desired sample collection point.
Cast aluminum seal housing
304 stainless steel sample probe, housing and covers
CONTROLS
Intersystems control packages are available to
suit any sampling control application. The standard units allow manual and automatic sampling operations. These units can handle a wide variety of voltages and frequencies and can be constructed for most environments.
POWER REQUIREMENTS
Electric: 110V single phase control
Pneumatic: 80 to 100 PSI
Industrial Sampling:
Intersystems is ISO 9001 and 14001 certified